MOISTURE REMOVER FG, 400ML

Moisture Remover FG prevents rust and corrosion on all ferrous and non-ferrous metals during storage, production and transport. Displaces and seals out moisture, especially after washing equipment. Penetrates through corrosion to loosen seized parts and lubricates without leaving a sticky residue. Cleans light soils and contaminants. Non-drying protective film prevents ‘fingerprinting’. Suitable at materials & equipment storage, post wash-down treatment, machined surfaces, corrosion protection and light lubrication.

• 400ml fill size
• AN001183 halal certified product
• 360° spray system for all angle use
• NSF registered category H1, no. 161243
• Clear appearance
• Specific gravity at 20°C is 0.83, freezing point is -10°C and flash point (open cup) is 78°C
• Ultimate film thickness is 2 x 10¯⁵m at 20°C, after a 24hr spread
• Maximum expected coverage is 100m2/l at 20°C, after a 24hr spread
• Solvent dissipation at 20°C, thin film is 2-4 h
• Salt spray resistance is 65h and heat resistance is 120°C (150°C short time)

Pastabos

Stored at normal ambient temperatures and has a shelf life of not less than 6 years with correct storage. Aerosols should always be stored below 50°C, away from direct heat and flame.