VA800A-SPI

The VA800A-SPI is an USB 2.0 high-speed to MPSSE SPI Module, small electronic circuit board, utilising the FTDI FT232H. The 10-pin connector on the module fits directly to the FTDI VM800B and VM800C graphic display modules. This allows direct control of the EVE FT800 devices with an SPI interface from a USB host. All USB signalling and protocols are handled on the module. The VA800A-SPI MPSSE module is configured for SPI only. The 10-pin connector fits to the VM800B and VM800C graphic display modules directly.

• USB 2.0 high-speed (480Mbps) and full speed (12Mbps) compatible
• Entire USB protocol handled on the chip - No USB-specific firmware programming required
• USB type-B micro connector
• USB bus powered
• Synchronous serial (MPSSE) data rates of up to 30Mbps on SPI
• 1kb receive and transmit buffers for high data throughput
• 3.3V level IO
• Power indicator LED
• SPI SS# active indicator LED
• Adjustable receive buffer timeout
• Support for USB suspend and resume
• Low operating and USB suspend current
• Low USB bandwidth consumption
• UHCI/OHCI/EHCI host controller compatible
• -40 to +85°C Operating temperature range
• FTDI chip's royalty-free D2XX drivers eliminate requirement for USB driver development in most cases

Pritaikymas

Computers & Computer Peripherals